Table of Contents
Table of Contents
Thanks and Intro
Important Safeguards
1. Specifications
2. Parts and Features
3. Operation
1
1
2
3
3
3
5
8
4. Troubleshooting
5. Limited Warranty
Thank you and Intro
Thank you for purchasing this EdgeStar wine cooler. Once you get this unit
set up, it will provide you and your family with years of great service.
If you are reading this owner’s manual, you’ve probably already unpacked the
unit. Note that you should save the packaging in case you need to safely
transport this wine cooler in the future.
In order to assemble this wine cooler, carefully
unpack all parts. The only assembly required is that
of the handle. In order to install the handle, you
need a phillips screwdriver, the handle, and the two
installation screws.
• Open the door of the wine cooler.
• Locate the two screw holes on the inside of
the door (they may be partially obscured by
the door liner gasket.) If the gasket obscures
the screw holes, gently pull that section of the
gasket out of the door.
• Insert the screws into the holes. They should
Note: Your door and
handle may appear
different than pictured
now poke out of the front of the door.
• Line up the holes in the handle with the
screws and give each screw about 2-4 full
turns into the handle.
• Now screw the screws in all the way, reset the gasket into the door (if
you removed it) and your handle is installed!
After you get the handle installed, make sure that your wine cooler is fully
unpacked, and position it where you want it to go (remember, for the best
conditions for your wine, choose a spot in a cool (room temperature) area, out
of the sun, and with about 2-4” around all sides and the back for adequate
ventilation. Make sure the unit is set on a sturdy surface that can support its
weight. Note that you can screw in and out the legs to level the unit. You may
also want to clean the interior with a solution of mild soap and water and a
damp cloth. Then plug the unit in, set the temperature, and fill it with wine.
At what temperature should you set the wine cooler? Some of the experts
differ in their opinions, but we recommend low to mid 50’s (F) for whites and
mid 60’s (F) for reds. Enjoy!
1
• An empty cooler can be dangerous for children. If disposing of the
cooler remove gaskets, latches, lids and the entire door from your
unused appliance, or take other action to ensure that children cannot
become trapped inside.
• If your model of wine cooler is equipped with a lock, take care to keep
the keys away from children.
• Do not cut or remove the third prong (the grounding prong) from the
power cord.
• The cord should be secured behind the unit and should not be left
exposed or dangling.
• Do not move this cooler without emptying it of its contents and securing
the door in a closed position.
1. Specifications
Model
TWR125SS
Voltage/frequency 115V/60Hz
Power
75 W
1.0 A
7.8 KG
I
Rated Current
Net Weight
Protection Type
SN • N
Climate Type
2. Parts and Features
Note: The above diagram is for reference only- your specific model of wine
cooler will likely differ slightly from the diagram above (in light placement,
bottle capacity, etc,) but its operation will be essentially the same.
3. Operation
The Temperature Control
Your wine cooler uses a manual control to adjust the thermostat-
Adjust the temperature using the dial located in the upper right hand corner
inside the wine cooler.
Interior Light
3
Your wine cooler has an interior light with an on/off switch. Turn the light on or
off by pressing the switch.
Leveling Legs
Your wine cooler is shipped with leveling legs installed. To adjust these
leveling legs, carefully lean the cooler to one side (make sure the cooler is
empty and the door is secured) and unscrew the leveling legs to make them
longer. Screw them in tighter to make them shorter.
Note: This cooler is not designed to operate with the leveling legs removed.
Bottle Capacity
Bottle capacity listed for your wine cooler is an estimated maximum capacity
based on standard 750 mL wine bottles. For any other size bottles, capacity
will vary.
Racks
Please note that the racks for your cooler have a top and a bottom. If you are
having trouble fitting the stated number of bottles in the cooler (provided you
have standard wine bottles), try flipping over one or more racks.
Also note that your wine cooler (depending upon the model) may have more
“slots” for racks than the number of racks provided with the unit.
Cleaning the Cooler
• Unplug your cooler. Remove all items from it (wine bottles, shelves,
etc.)
• Wash the inside surfaces with a mild cleaner. We suggest you use
either warm water alone, or a baking soda solution (try mixing 2
tablespoons of baking soda into a quart of water.)
• Wash the wire shelves/trays (if you have them) with a mild detergent
solution.
• Clean the wooden shelves/trays (if you have them) with a soft cloth and
some wood cleaner.
• Wash the outside of the cooler with a mild detergent solution.
• Dry any wet parts with a soft cloth.
Caution: make sure to minimize the exposure of water to any electronic or
control parts.
Extended Periods of Disuse
Your cooler can operate safely for three weeks or longer without any
adjustments. However, if the cooler is going to be left alone for several
months, you should unplug it and clean it according to the instructions above.
Pay special attention to drying the interior.
Now set the unit aside somewhere safe. You may want to crack the door
slightly to prevent mold growth or odor.
Transporting the Cooler
The ideal packaging for you cooler is its original packaging. If possible, keep
this packaging handy and repack the cooler as it was initially packed if you
need to transport it.
If you do not have the original packaging:
4
• Make sure the cooler is turned off and unplugged.
• Remove all items.
• Tape down the shelves and any other loose items within the cooler.
• Shut the door and tape it closed.
• Transport the cooler in a secure, upright position.
• Protect the outside of the cooler with Styrofoam, cardboard, a blanket,
etc.
Energy Efficiency Tips
Locate your cooler in the coolest area of the room.
Locate your cooler away from direct sunlight or any heat-producing sources.
Let any hot foods or drinks cool before placing them inside the cooler.
5. Troubleshooting
Your EdgeStar wine cooler is a thermoelectric refrigeration unit that uses
“green” thermoelectric cooling to store your wine under ideal conditions.
What are the benefits of thermoelectric cooling?
• Low energy usage
• No vibration
• Cools with little noise- the only noise produced is by the fans used to
dissipate heat.
What are some of its limitations?
• Cooling takes longer than with equivalent compressor-based units- you
must allow 24 hours or more for the unit to reach its lowest temperature
• Fans run constantly
• Units are more sensitive to ambient temperature, sunlight conditions,
and potentially loading conditions- they may not cool to their theoretical
minimum temperature under adverse conditions
5
Symptoms
Possible causes
Solutions
There is a power
failure.
Ensure the cooler is
plugged in and the
power outlet has power.
The wine
cooler does
not turn on.
The cooler is not
plugged in.
Replace the broken fuse
in your fuse box or reset
the breaker.
A house fuse has
blown or the circuit
breaker is tripped.
The cooler is placed
too close to a heat
source.
Keep the cooler away
from sunshine or other
heat sources.
The wine
cooler will not have sufficient
reach the
desired
The cooler does not
Make sure the wine
cooler has several
inches of ventilation on
the sides and back.
ventilation.
temperature
The door is opened
Close the door tightly
too frequently or for a and do not open the door
long period of time.
too frequently or for a
long period of time.
The environment is
humid.
Though the unit uses an
“auto-defrost” system,
under certain conditions,
manual defrosting may
be required. If frost
builds up, you can try
running the cooler on a
warmer temperature
setting, minimizing the
number of times you
open the door, or
The ambient
temperature is too
low.
Frost is
forming in the
wine cooler
The door is being
opened too
frequently.
unplugging the unit to
allow the frost to melt.
6
Symptoms
Possible causes
The room
Solutions
Run the cooler in the
temperature is higher appropriate ambient
than the
temperature.
recommended
ambient temperature
(77°F).
Minimize the number of
times the door is
opened.
The door is being
opened often.
The cooler
turns on and
off frequently.
Make sure the door is
completely closed.
The door is not
completely closed.
Make sure the door
gasket is properly
sealing.
The door gasket is
not sealing properly.
Make sure the cooler
has at least 2” on the
sides and 4” in the back
for clearance.
The cooler does not
have the suggested
ventilation.
If the noise is from
the fan, it may be
normal operating
noise.
The fan makes normal
fan noises when
operating- this is normal.
Make sure the cooler is
on a level surface.
The cooler
makes too
much noise.
The unit is not level.
Popping or crackling
noises are coming
from the unit.
Some popping or
crackling noises are
normal. They are caused
by expansion and
contraction of the inside
walls due to temperature
changes.
Your cooler is not
level.
Make sure the cooler is
on a level surface.
The door gasket is
Clean the door gasket.
The door will dirty.
not shut
Make sure the door
gasket is properly
sealing.
properly.
The door gasket is
malformed.
The shelves are
incorrectly installed.
Correctly install the
shelves.
7
6. Limited Warranty
This EdgeStar product is warranted to be free from defective workmanship
and materials for the first year following the date of original purchase.
Replacement parts will be supplied free of charge for the first year following
the date of original purchase. Labor will be performed free of charge for the
first 90 days following the date of original purchase.
WHAT IS COVERED:
This warranty applies to the original purchaser only, and only covers defects
in workmanship experienced during operation of the product under normal
service, maintenance, and usage conditions. This warranty applies to the
purchase and use of this product in residential settings within the United
States of America.
WHAT IS NOT COVERED:
The following limitations apply to the coverage of this warranty:
Optional accessories, attachments, and appearance items are excluded from
warranty coverage, as is shipping damage, and any damage caused by
improper voltage or any other misuse, including abnormal service, handling,
or usage.
This warranty does not cover normal wear and tear on parts or replacement of
parts designed to be replaced, e.g. filters, etc.
This warranty does not cover service trips to deliver, pick-up, repair, or install
the product, or to instruct in proper usage of the product.
Damages or operating problems resulting from abuse, operation outside
environmental specifications, uses contrary to instructions provided in the
owner’s manual, accidents, vermin, fire, flood, improper installation,
unauthorized service, acts of God, unauthorized installation or modification, or
commercial use are excluded from warranty coverage.
This warranty does not cover labor incurred 91 days or more after the date of
original purchase.
This warranty does not cover use of EdgeStar products in commercial
settings.
DESCRIPTION OF WARRANTY SERVICE:
All defective product components covered by this warranty will be repaired or
replaced, at EdgeStar’s option, free of charge on a mail-in basis to EdgeStar’s
authorized repair facility during the first 90 days from the date of original
purchase.
All defective product components covered by this warranty will be repaired or
replaced, at EdgeStar’s option, on a mail-in basis to EdgeStar’s authorized
repair facility during the time period beginning on the 91st day from the date of
original purchase and ending one year from the date of original purchase.
During this time period, parts will be supplied free of charge, but labor charges
will apply.
All replacement parts and units will be new, remanufacturered, or refurbished.
All products and components replaced by EdgeStar under warranty service
become the property of EdgeStar.
8
OBTAINING WARRANTY SERVICE:
Contact EdgeStar for troubleshooting assistance and warranty service
authorization at 1-866-319-5473. Please have your order receipt available to
confirm the date of purchase.
Once an EdgeStar authorized representative has confirmed that your product
is eligible for warranty service, the product must be returned to an EdgeStar
authorized repair facility.
The purchaser is solely responsible for prepaying all shipping related costs to
and from the repair facility.
EdgeStar is not responsible for damage resulting from shipper mishandling or
improper packaging.
Do not return defective product to the place of purchase.
THIS WARRANTY IS IN LIEU OF ANY OTHER WARRANTY, EXPRESS OR
IMPLIED, INCLUDING WITHOUT LIMITATION, ANY WARRANTY OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. TO
THE EXTENT ANY IMPLIED WARRANTY IS REQUIRED BY LAW, IT IS
LIMITED IN DURATION TO THE EXPRESS WARRANTY PERIOD ABOVE.
NEITHER THE MANUFACTURER NOR ITS DISTRIBUTORS SHALL BE
LIABLE FOR ANY INCIDENTAL, CONSEQUENTIAL, INDIRECT, SPECIAL,
OR PUNITIVE DAMAGES OF ANY NATURE, INCLUDING WITHOUT
LIMITATION, LOST REVENUES OR PROFITS, OR ANY OTHER DAMAGE
WHETHER BASED IN CONTRACT, TORT, OR OTHERWISE. SOME
STATES DO NOT ALLOW THE EXCLUSION OF INCIDENTAL OR
CONSEQUENTIAL DAMAGES, SO THE ABOVE EXCLUSION MAY NOT
APPLY TO YOU. THIS WARRANTY GIVES YOU SPECIFIC LEGAL
RIGHTS. YOU MAY HAVE OTHER RIGHTS THAT VARY FROM STATE TO
STATE.
9
|